DuraGates CGI-350.5P, Large Carriage, Monobloc Body
Hardware
CGI-350.5P
DuraGates CGI-350.5P, Large Carriage, Monobloc Body
Monobloc carriage body with 5 wheels and sealed bearings. Large pivot allows for increased weight capacity, smooth sliding and stability. Larger wheel dimensions increase the weight capability and reduce wear and tear between wheels and tracks.
CGI-345P
Medium Stainless Steel Track
Stainless steel tracks are structurally sound which gives them flexibility and permits carrying high loads without distortion. You can build the gate right on the track.
CGI-347P
End Wheel for Track
The End Wheel bolts into each end of the track and complies with UL325 safety code for automated gates. It gives a finished look and prevents dirt, snow, etc. from getting inside the track and interfering with the operation of the carriages. The wheel allows the gate to roll into the bottom
end cup without scraping the paint or galvanized coating.
CGI-346P
Bottom End Cup for Track
This cup receives the track in either the closed or open position. The beveled leading edge allows for a smooth entry and stop. The cup holds the gate steady, reducing vibrations from wind conditions, etc., and prolongs the life of the carriages and gate operators.
CGI-348-M16
J-Bolt, Galvanized
Galvanized J-Bolts are set into the concrete pad as it is poured. Once it has cured, the carriages are then secured to the pad using these bolts. J-Bolts are the preferred method of anchoring the carriages to the concrete pad. Wedge anchors with two-part epoxy will work but need to be sized to each load according to manufacturer’s recommendations.
CGI-05P
Foundation Plate
A recommended accessory to mount the carriage to. This prevents the carriage from coming in direct contact with the ground and also gives a more finished look to the installation. It will also provide a sturdier base for the carriage and assist in leveling.
CG-PBSP
Post Mount Bracket for Large "P" Carriages, Use with 4" sq. Tubing
Cantilever post mount bracket options for use with Comunello "P" series carriages. Securely attach each carriage to a 4-in round or 4-in square support post. The sturdy galvanized steel brackets offer a traditional installation method for the installer, allowing for an easier installation by eliminating the need to pour a large foundation. Post brackets also offer easier adjustment and gate alignment. No cement pad is required, but we recommend that each cement embedded post have a minimum hole diameter of 20" and a minimum depth of 48".
CG-PBRP
Post Mount Bracket for Large "P" Carriages, Use with 4" dia. Tubing
Cantilever post mount bracket options for use with Comunello "P" series carriages. Securely attach each carriage to a 4-in round or 4-in square support post. The sturdy galvanized steel brackets offer a traditional installation method for the installer, allowing for an easier installation by eliminating the need to pour a large foundation. Post brackets also offer easier adjustment and gate alignment. No cement pad is required, but we recommend that each cement embedded post have a minimum hole diameter of 20" and a minimum depth of 48".